#6 in the series.
We will start by attaching the rear fuselage attachment gussets. There are six: two on each side, and two on the bottom. The top side gussets, the bottom side gussets, and the bottom gussets are each unique. They may vary slightly from these photos in appearance, due to fit and lightening improvements. Fit, cleco, and rivet them in place, as shown in the following photos:
|Bottom Side Gusset and Bottom Gusset, clecoed in place|
|Bottom Side Gusset, riveted in place|
|Top and Botom Side Gussets, riveted in place|
|Bottom Gusset, clecoed in place.|
Rivet all six gussets in place.
Now we will work on attaching the ‘sun roof skin’ to the top of the cabin.
|The front vertical pieces are marked and cut off with a dremel tool.|
After cutting off the vertical angle aluminum supports, we can add in the two cross tube supports, which were are cut from 1″ 6061T6 .063 square tubing.
|6061T6 1 x 1 x .063 cross bars. Cut to length shown.|
|All top cabin tubing shown|
|Top skin clecoed in place.|
|Another view of top skin clecoed in place.|
|Small inside gussets for top of cabin.|
|Riveting the top sunroof skin in place.|
|Closeup of corner of top skin.|
You’ll need to make a bend in the windshield support.
|Windshield support with bend.|
|Windshield support clecoed in.|
|Windshield support riveted in.|
Now it’s time to cleco in the remaining baggage compartment dividers.
Pay attention: the tabs may be bent either way, but only one way is correct. Study the parts, your assembly to date, and all of the photos to ensure that you do it correctly. The tabs are easily bent in any brake or even with a bench vise. There are also hand tools which make them easy.
|Baggage compartment divider.|
|Baggage compartment dividers in place.|
Note that the bottom skin is not entirely pre-drilled. This allows you to fit the best alignment on your baggage divider skins and under the front floor pan (which may require you to drill out a few rivets to fit under).
|Bottom skin, ready to install.|
|Bottom skin clecoed in place, fit under floor pan and under landing gear gusset.|
|Bottom skin partially riveted in place.|
|Rear Landing Gear gussets clecoed in place.|
|Fabric trim plate for bottom landing gear cross attach post.|
|Fabric trim plate riveted in place.|
|Front Diagonal Support gusset, bent and riveted in place.|
|Front Diagonal Support gusset, riveted in place.|
|Doublers at engine mount area|
|Doublers at engine mount area, riveted in place.|
|Top of cabin, ready to accept gusset.|
|Gusset riveted in place. One of these rivets will be drilled out.|
One of the rivets will be drilled out in order to accept the “X” steel cross brace.
NEXT: PHOTO REVIEW OF THE CABIN ASSEMBLY, PRIOR TO COVERING.